BEAUTIFUL BRIDGE CURB AT STATE SPECIFICATIONS
Williams Stone Company offers a complete line of bridge curbing fabricated at our East Otis facility. It is available predrilled for anchors in straight and curved curbing, as well as in a variety of sizes and finish treatments.
Bridge curbing can be provided in a variety of lengths. See the bridge curb section of our detail drawings page for the following state specifications:
Connecticut: 6"x 9½" or 12" bridge curb, straight & radius, manufactured in accordance with M.12.06 of the State of Connecticut Department of Transportation Standard Specifications for Highways and Bridges.
Massachusetts: 6" x 8" granite bridge curb, straight & radius, manufactured in accordance with M9.04.1, section 501.66 of the Commonwealth of Massachusetts Department of Public Works Standard of Specification for Highways and Bridges.
New York State: NYS F-1, 5" x 5.5" [IN STOCK] NYS G-1, 5" x 7.5 NYS R-1, 9" x 13.5"
Rhode Island 6" x 9" 10" x 15" Sloped Face
For states requiring different specifications, contact Williams Stone Company. We can easily meet your requirements.
Edge Detail Options
There are five basic edge details that may be specified to the exposed edges of a bridge curb:
Straight edge (standard).
Buzzed: 1/4-inch camfer (or eased) edge.
Rounded edge: one or both edges are chamfered and then rounded off to 1/2-inch or greater radius.
Chamfer: 45-degree bevel is standard, 1/2", 3/4: or 1".
Beveled mountable: 45-dgree chamfer is standard, up to 3" x 3" or 4" x 4", or 5" x 5".
There are three basic joint options available for bridge curbing:
Full: a straight cut with 90-degree angles at top and bottom. Unless otherwise specified, this joint is considered standard.
Mitered: an angled cut, top to bottom, for matching faces at expansion joints, etc. Angles for miters must be supplied or noted on approved submittals.