GRANITE CURBING
TRANSITION CURB
STRAIGHT OR CURVED TRANSITION CURBS TO MEET YOUR REQUIREMENTS
Williams Stone Company offers a variety of straight and curved transition curbs to meet your driveway transition and/or ADA requirements, including handicap accessible transition ramps, standard driveway transitions, and vertical-to-slope transitions.
Transition Sizing
Custom transitions can be sawn from mountable to flush. They can be made from 2-foot up to 6.5-foot lengths.
Handicap & Driveway Transition Ramps
Handicap & driveway ramp transitions, from reveal to flush, are typically created using a straight or curved vertical curb with an angle joint at both ends. Sawn transitions must be custom ordered.
Vertical-to-Slope Transitions
Vertical-to-Slope transitions are used to transition from vertical granite curb or inlets to sloped granite edging. Standard vertical-to-slope transition curbs pitch the face to a 45-degree angle at one end from perfectly vertical at the other end.
Edge Detail Options
Straight edge (standard).
Buzzed: 1/4-inch camfer (or eased) edge.
Rounded edge: one or both edges are chamfered and then rounded off to 1/2-inch or greater radius.
Chamfer: 45-degree bevel is standard, 1/2", 3/4: or 1".
Beveled mountable: 45-dgree chamfer is standard, up to 3" x 3" or 4" x 4", or 5" x 5".
Joints
Standard joint or driveway and ADA ramp transition is a specified angle at both ends.
Standard joint on vertical-to-slope transition is straight.
We're ready to fill your order and ship direct to your job site with minimal lead times.
Contact Pat Wilson in our Curbing Products Department today!